Lighting is the job that changes how a room feels more than any other electrical work, and it is also where the difference between a careful installer and a fast one shows up permanently in your ceiling.
Work is performed under NJ Electrical Contractor Bus. Permit #34EB01810700, out of our Hazlet and Bridgewater offices. We pull the permits, keep the process seamless, and make sure the job gets done right.
Lighting Work We Handle
Recessed Lighting
New cans and retrofit LED fixtures, laid out for the room rather than spaced evenly and hoped for. We check joist direction and insulation before cutting anything.
Chandeliers and Statement Fixtures
Heavy multi-tier fixtures, two-story foyers and stairwell installations that need proper boxes, support and rigging rather than a standard fixture strap.
Exterior and Landscape Lighting
Wall lanterns, soffit and path lighting, and low-voltage landscape runs on weatherproof circuits sized for the distance. See our landscape and outdoor lighting services.
Under-Cabinet, Track and Flush Mount
Kitchen task lighting, track systems and flush mounts, including the switching and dimming so it behaves the way you expect.
What Decides the Price of a Lighting Job
Standard fixture replacements usually run $229.99 to $389.99. Large or complex chandelier installations — heavy crystal, high ceilings, rigging — often range from $3,500 to $9,000 depending on support and access.
CEILING HEIGHT AND ACCESS
A fixture at eight feet and the same fixture in a two-story foyer are not the same job. Height drives equipment, time and how many people are on site.
FIXTURE WEIGHT
Anything heavy needs a fan-rated or fixture-rated box and often blocking above the ceiling. This is the step people skip and later regret.
IS THERE A CIRCUIT ALREADY
Adding cans where there is existing switched power is straightforward. Running a new circuit back to the panel is a different job with a different price.
SWITCHING AND DIMMING
Three-way switching, dimmers matched to the LED driver, and smart controls all add wiring. Mismatched dimmers are the number one cause of flickering LEDs.
CEILING TYPE
Plaster, vaulted, cathedral and insulated ceilings each change how a can gets in and how the wire gets to it.
Lighting Controls We Install
We are a Lutron certified installer, and on the controls side we stick to Lutron and Leviton because the dimming actually behaves and the parts are available everywhere. Fixtures themselves are your choice — we install what you buy.
- Lutron — Certified installer. Dimmers, switches, Caseta and lighting controls. We are certified on Lutron controls; we do not install Lutron lighting panels.
- Leviton — Switches, dimmers, smart switches and weatherproof exterior devices.
We are not a single-brand shop. If you have a preference we will work with it; if you do not, we will tell you what we would put in our own house and why.
How a Lighting Installation Runs
LAYOUT AND WALKTHROUGH
We mark the layout on the ceiling with you before a single hole is cut, and check joists, ductwork and insulation above it.
CIRCUIT AND CONTROL PLAN
We confirm whether existing switched power is enough or a new circuit is needed, and match the dimmer to the fixtures so nothing flickers.
INSTALLATION
Cutting, wiring, mounting and trimming, with drop cloths down and the dust contained rather than tracked through the house.
DIMMING AND CLEAN-UP
We set the dimmer trim, confirm every switch does what it should, and clean the work area before leaving.
What Our Customers Say
Verified Google reviews from homeowners and businesses across Central New Jersey.
Where We Install Lighting
We do this work across Monmouth, Middlesex, Somerset, Union, Morris and Essex counties. Every town is listed on our service areas page.
Lighting Questions, Answered
How much does it cost to install a light fixture?
Standard fixture replacements usually run $229.99 to $389.99. Large or complex chandelier installations with heavy crystal, high ceilings or rigging requirements often range from $3,500 to $9,000. The fixture itself is separate — you buy what you like and we install it.
How much does recessed lighting cost per can?
It depends heavily on whether there is existing switched power, the ceiling type and the access above it. A retrofit into an accessible attic is a very different job from cutting into a plaster cathedral ceiling. We quote the room, not the can.
Why do my LED lights flicker on the dimmer?
Almost always a dimmer that is not matched to the LED driver. Older incandescent dimmers do not work correctly with LEDs. Swapping to a compatible LED dimmer fixes it in most cases.
Can you hang a heavy chandelier on an existing box?
Only if that box is rated for the weight, and most standard boxes are not. Heavy fixtures need a fixture-rated or fan-rated box and often blocking above the ceiling. We check before we hang anything.
Do I need a permit for lighting work?
Replacing a fixture on an existing circuit generally does not require a permit. Adding new circuits, new recessed lighting runs or exterior circuits usually does. We tell you which side of that line your job falls on.
Do you install lighting you did not supply?
Yes. Most of our lighting work is fixtures the homeowner or their designer chose. We install what you buy and tell you in advance if a fixture needs support you do not currently have.
Get a Lighting Quote
Send a photo of the room and the fixture you have in mind and we can usually tell you what is involved before scheduling anything.
See Our Recent Work Near You
Every pin is a real job our crews have photographed on site. Zoom in on your town to see what we have been working on nearby.
See our Google reviews: Hazlet · Bridgewater →
See Our Lighting Work
Meet the Crew
Locally owned and run. This is the team that shows up at your door.
