A ductless mini-split is the answer for the room your central system never reaches — a converted attic, a sunroom, an addition, a garage workshop. It is also a heat pump, which means it heats as well as cools.
Work is performed under NJ HVAC License #19HC00702000, out of our Hazlet and Bridgewater offices. We pull the permits, keep the process seamless, and make sure the job gets done right.
Mini-Split Work We Handle
Single-Zone Systems
One outdoor unit, one indoor head. The straightforward answer for an addition, converted space or a room that is always the wrong temperature.
Multi-Zone Systems
One outdoor unit feeding several heads on independent controls, so bedrooms are not fighting over one thermostat.
Line Set and Electrical Hook-Up
Line set routing, condensate management, dedicated circuit and disconnect — the electrical side is where we started and it shows in the finished work.
Garage, Workshop and Attic Conditioning
Spaces the ducted system was never designed to serve, conditioned without extending duct into places it does not want to go.
What Decides the Cost of a Mini-Split
Mini-split pricing depends on how many heads, how far the line set has to run, and whether the panel can carry the new circuit. We quote after seeing the space and the panel.
NUMBER OF ZONES
Each indoor head adds equipment, line set and labor. Multi-zone is not simply single-zone multiplied, but it is not free either.
LINE SET DISTANCE AND ROUTE
A head on the wall directly behind the outdoor unit is a fraction of the work of a run through finished space to the far side of a house.
ELECTRICAL CAPACITY
Every system needs a dedicated circuit and a disconnect. If the panel is full, that becomes part of the conversation before anything is ordered.
CONDENSATE HANDLING
Gravity drain where possible, condensate pump where not. Getting this wrong is what stains ceilings a year later.
COSMETICS
Line-hide covering, interior soffit routing and mounting height all affect labor. Some people care a great deal and some do not.
Mini-Split Equipment We Install
We install serviceable, widely supported ductless equipment. Parts availability matters more on inverter equipment than on almost anything else in the house.
- Fujitsu — Single and multi-zone ductless systems with a strong low-temperature heating record.
- Bosch — Inverter-driven ductless and light commercial equipment where efficiency is the priority.
How a Mini-Split Installation Runs
SITE AND LOAD REVIEW
We measure the space, work out the head size and plan where the outdoor unit and line set can realiztically go.
ELECTRICAL CHECK
We open the panel and confirm capacity for the dedicated circuit before recommending equipment, not after it has been delivered.
INSTALLATION
Heads mounted, line set run and properly evacuated, condensate handled, dedicated circuit and disconnect installed by our own electricians.
COMMISSIONING
We verify charge, check operation in both heating and cooling, and walk you through the controls before leaving.
What Our Customers Say
Verified Google reviews from homeowners and businesses across Central New Jersey.
Where We Install Mini-Splits
We do this work across Monmouth, Middlesex, Somerset, Union, Morris and Essex counties. Every town is listed on our service areas page.
Mini-Split Questions, Answered
Does a mini-split heat as well as cool?
Yes. A ductless mini-split is a heat pump, and modern units hold useful heating capacity well below freezing. For many New Jersey homes it becomes the primary heat in the space it serves.
Do I need one head per room?
One head conditions one open space well. It will not push conditioned air around a corner or through a closed door. Multi-zone systems use one outdoor unit with several heads on independent controls.
Does a mini-split need its own electrical circuit?
Yes. Every system needs a dedicated circuit sized to the equipment and a disconnect at the outdoor unit. We handle that in house rather than subcontracting the electrical side.
Are they noisy?
The indoor head is quiet — usually quieter than a refrigerator. The outdoor unit makes noise, which is why placement relative to bedrooms and neighbors is worth a conversation before we mount it.
Can you hide the line set?
Largely. Line-hide covering tidies exterior runs and interior routing through soffits or closets is often possible. Fully concealed runs cost more, and we will tell you what is realiztic for your walls.
Do mini-splits need permits?
Yes. Installation requires a permit and inspection, including for the electrical circuit. We file it and handle the permit as part of the job.
Get a Mini-Split Quote
Tell us which room never gets comfortable and roughly where your panel is, and we can scope a system before coming out.
See Our Recent Work Near You
Every pin is a real job our crews have photographed on site. Zoom in on your town to see what we have been working on nearby.
See our Google reviews: Hazlet · Bridgewater →